Hi Stampers!
This card was a suggestion from my friend and downline Donna.
I cannot thank her enough as this was a super fun card to create.
The card design was by Lisa and you can find her at Queen B creations.
I had never made one of these cards before because to be honest it looked HARD….and Complicated!
Lisa’s tutorial proved me wrong and I am so glad, so I am happy to share it with you 🙂
If you have a card idea, project or other idea you’d like to see made, drop me a line at Rachthestamper@gmail.com
The measurements are below along with directions, but also be sure to check out the video for a step by step instruction.
CARD RECIPE
Base card: 4 1/4″ by 11″, score at 5 1/2″
Pop-Mechanism panels: 2 1/2″ by 8″, 2 1/2″ by 10″
DSP Inside panels: 4″ by 5 1/4″ ,you need two
Basic Gray panels: 2 1/4″ by 2 1/4″, you need four
Whisper White panels: 2″ x 2″ you need four, 3 3/4″ by 3 3/4″ for inside to write note
On the 10″ piece: this is your panel mechanism
10″ side: Score at 2 1/2″, 5″, 7 1/2″
On the 8″ piece:Â this is your movement mechanism
2 1/2″ side: Score at 1 1/4″
Then on the 8″ side, mark with your scoring tool just a bit at the top at 2 3/4″ and 5 1/4″, flip and repeat on other side. Then lining up the opposite 2 3/4″ and 5 1/4″ mark, score DIAGONALLY on the Simply Scored or Stampin’ Trimmer, flip and repeat.
This will make a cross in the middle.
Make sure you reinforce the folds well with your Bone Folder.
You will want to mark the center of the bottom inside panel so it is centered, I did so with a pencil at 2 1/8″
Once this is attached, you will want to make the center with a pencil at 4″ to center the panel portion
Until next time,
Stay Crafty!
XO Rach
Product List
Social Media Links
Follow me on Facebook!
Follow me onInstagram
Check out some great Pins
Shopwith me
Blogwith me
Chat with me at Rachthestamper@gmail.com
Leave a Reply